PM06D Power Module (14S)
PM06D Power Module (14S) to make current flow regulary
PM06D Power Module (14S) integral with CubePilot and Ardupilot
PM06D Power Module provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. It has built-in power distribution, allowing you to power your ESC and FC with the same board.
The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with an XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.
CURRENT RATING
The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as a reference.
PX4 PARAMETER SETUP:
- If you are using the PM06D 14S version, you must set SENS_EN_INA228 to enable.
SPECIFICATION
- Input voltage: 2S- 14S
- PCB Cont. Current Rating: 70A
- PCB Burst Current Rating: 120A (<60 Sec)
- Max current sensing: 327A
- Voltage and current monitor with I2C compatible interface
- Connector Outputs: 5.2V and 3A max
- Weight: 24.5g
PACKAGE DETAIL
- 1x PM06D Power Module
- 1x 6pin 2.00mm pitch cable