Matek Hall Current Sensor 150A - reliable current measurement!
A current sensor based on the Hall effect. Targeted at systems that do not have a built-in current sensor or system integrators who want to avoid voltage drop or excessive heat generation as with traditional resistor-based current sensors. This sensor, should be mounted away from iron or materials with magnetic properties. Sensitivity and offset are calibrated by the factory.
Matek Hall Current Sensor 150A Soldering pads
- VBAT: for voltage detection, supports: 0 ~ 69V IN
- Volt: = 1/21 Vbat, 0~3.3V out
- Curr: Current signal, 0~3.3V out
- 5V: power supply for HCS-150A board, support 4~13V IN, 17mA
- G: GND
- TX/RX: for firmware update and configure (to be supported)
Matek Hall Current Sensor 150A Specification
Continuous current rating
| 0 ~ 150A DC |
Sensitivity
| 20mV/A INAV/Betaflight scale = 200 ArduPilot BATT_AMP_PERVLT = 50 |
VBAT voltage sense
| 0 ~ 69V INAV scale = 2100 Betaflight scale = 210 ArduPilot BATT_VOLT_MULT = 21.0 |
Power Consumption
| 17mA |
Voltage offset error at zero current
| +-10mV |
Curr output voltage error
| 5% |
Operating Temperatures | -30 ~ 80 °C |
Dimensions | 23 * 20* 23mm |
Weight | 7g |
Package Matek Hall Current Sensor 150A includes
- 1x Matek Hall Current Sensor 150A