AP_PERIPH CAN RC INPUT ADAPTER

AP_PERIPH CAN RC INPUT ADAPTER

Upgrade your RC system with the L4 RC CAN adapter from Matek. Powered by ArduPilot AP_Periph software, this innovative device transforms a serial receiver into a versatile CAN (Controller Area Network) receiver.

• CAN-L4-RC is an adapter based on ArudPilot AP_Periph software.
• With this adapter you can convert a serial receiver into a CAN receiver.

SPECIFICATION

• MCU: STM32L431xC, 256KB Flash
• 1x CAN, DroneCAN Protocol
• 1x UART(UART3, Tx3/ Rx3)
• ST debug, SWCLK & SWDIO
• LED (Blue, Fast blinking,  Booting, Blue, Slow blinking, working)
• Input voltage range: 4.5~5.5V  @5V pad/pin
• Power consumption: 10mA
• Operating Temperatures: -40~85 °C
• Physical (1x JST-GH-4P(SM04B-GHS-TB) for CAN; 2.54mm pitch holes for UART3; Board Size: 23mm*12.5mm.  2.5g)
• Firmware (ArduPilot AP_Periph  MatekL431-RC; Update via DroneCAN GUI Tool)

PACKAGE DETAIL

• 1x CAN-L4-RC board
• 1x JST-GH-4P to JST-GH-4P 20cm silicon wire