Reliable measurement of current!
A current sensor based on the Hall effect. Targeted at systems that do not have a built-in current sensor or system integrators who want to avoid voltage drop or excessive heat generation as with traditional resistor-based current sensors. This sensor, should be mounted away from iron or materials with magnetic properties. Sensitivity and offset are calibrated by the factory.
SOLDERING PADS
- VBAT: for voltage detection, supports: 0 ~ 69V IN
- Volt: = 1/21 Vbat, 0~3.3V out
- Curr: Current signal, 0~3.3V out
- 5V: power supply for HCS-150A board, support 4~13V IN, 17mA
- G: GND
- TX/RX: for firmware update and configure (to be supported)
Specyfikacja Hall Current Sensor 150A
Stały prąd znamionowy | 0 ~ 150A DC |
Czułość | 20mV/A, INAV/BF skala = 200, ArduPilot BATT_AMP_PERVLT = 50 |
Wykrywanie napięcia VBAT | 0 ~ 69V, INAV skala = 2100, BF skala = 210, ArduPilot BATT_VOLT_MULT = 21.0 |
Pobór prądu | 17mA |
Błąd offsetu napięcia przy zerowym prądzie | +-10mV |
Błąd napięcia wyjściowego prądu | 5% |
Temperatura pracy | -30 ~ 80 °C |
Wymiary | 23 * 20* 23mm |
Masa | 7g |
ZESTAW ZAWIERA
- 1x Hall Current Sensor 150A